Installation [03/2017 - 06/2017]: Procedure
- INSTALL CHILD RESTRAINT SEAT TETHER ANCHOR BRACKET
HINT:
Use the same procedure for all child restraint seat tether anchor brackets.
- Engage the guide and install the child restraint seat tether anchor bracket with the bolt.
Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf)
- Engage the guide and install the child restraint seat tether anchor bracket with the bolt.
- INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY
See step 5
- INSTALL REAR SEAT SHOULDER BELT HOLE COVER
See step 6
- INSTALL CENTER STOP LIGHT SET
Refer to INSTALLATION [03/2017 - ]
- CONNECT REAR SEAT OUTER BELT ASSEMBLY LH
See step 8
- CONNECT REAR SEAT OUTER BELT ASSEMBLY RH
HINT:
Use the same procedure as for the LH side.
- INSTALL INNER ROOF SIDE GARNISH LH
Refer to PROCEDURE - Step 20
- INSTALL INNER ROOF SIDE GARNISH RH
HINT:
Use the same procedure as for the LH side.
- INSTALL REAR SIDE SEATBACK ASSEMBLY LH
Refer to PROCEDURE - Step 1
- INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH
Refer to PROCEDURE - Step 25
- INSTALL REAR SIDE SEATBACK ASSEMBLY RH
HINT:
Use the same procedure as for the LH side.
- INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH
Refer to PROCEDURE - Step 36
- INSTALL REAR SEAT CUSHION LOCK HOOK
Refer to PROCEDURE - Step 7
- INSTALL REAR SEAT CUSHION ASSEMBLY
Refer to PROCEDURE - Step 8
- CONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY
Refer to PROCEDURE - Step 9
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Refer to INITIALIZATION [03/2017 - 06/2017]
- PERFORM DIAGNOSTIC SYSTEM CHECK
Refer to DTC CHECK / CLEAR [03/2017 - ]
- INSPECT SRS WARNING LIGHT
Refer to OPERATION CHECK [03/2017 - 06/2017]