On-Vehicle Inspection [03/2017 - ]: Procedure
- INSPECT DOOR SIDE AIRBAG SENSOR (for Vehicle not Involved in Collision)
- Perform a diagnostic system check.
Refer to DTC CHECK / CLEAR [03/2017 - ]
- Perform a diagnostic system check.
- INSPECT DOOR SIDE AIRBAG SENSOR (for Vehicle Involved in Collision and Airbag not Deployed)
- Perform a diagnostic system check.
Refer to DTC CHECK / CLEAR [03/2017 - ]
- Visually check the door side airbag sensors for defects if a front door of the vehicle or the area around a front door is damaged.
HINT:
The defects are as follows:
- Cracks in the sensor housing
- Dents in the sensor housing
- Chips in the sensor housing
- Cracks or other damage to the connector
- Damage to the waterproof rubber seal
OK
No defects are found.
If any defects are found, replace the door side airbag sensor with a new one.
- Perform a diagnostic system check.
- INSPECT DOOR SIDE AIRBAG SENSOR (for Vehicle Involved in Collision and Airbag is Deployed)
- When airbags have deployed as the result of a collision, be sure to replace all door side airbag sensors in the damaged areas (anywhere in need of repair).
- Visually check the door side airbag sensors in undamaged areas for defects.
HINT:
The defects are as follows:
- Cracks in the sensor housing
- Dents in the sensor housing
- Chips in the sensor housing
- Cracks or other damage to the connector
- Damage to the waterproof rubber seal
OK
No defects are found.
If any defects are found or a door side airbag sensor has detected a major collision, replace the door side airbag sensor with a new one.