LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Camry LE, FWD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System - Service Information (2 Of 2) (Except Hybrid) >> Center Airbag Sensor Assembly >> Removal [10/2020 - ] >> Caution / Notice / Hint

Caution / Notice / Hint

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during airbag sensor assembly removal/installation are shown below.

NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Replacement of the airbag sensor assembly
  • Perform "Reset Memory"
  • Perform acceleration sensor zero point calibration and system information memorization
  • VSC disabled or malfunctioning
  • DTCs are output
  • Slip indicator light illuminated
  • ABS warning light illuminated
 w/o Electric Parking Brake System: Refer to CALIBRATION [10/2020 - 08/2021] , or refer to CALIBRATION [08/2021 - ]
w/ Electric Parking Brake System: Refer to CALIBRATION [10/2020 - 08/2021] , or refer to CALIBRATION [08/2021 - ]
Reset memory Dynamic torque control AWD system Refer to CALIBRATION [03/2020 - ]
Removal/installation of the front passenger seat Zero point calibration (Occupant classification system)
  • Occupant classification system
  • Passenger airbag ON/OFF indicator
  • Airbag system (Front passenger side)
  • Seat belt warning system (Front passenger)
 Refer to INITIALIZATION [06/2017 - ]
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane tracing assist system Refer to INITIALIZATION [10/2020 - ]
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system Refer to INITIALIZATION [03/2017 - ]
Panoramic view monitor system Refer to INITIALIZATION [10/2020 - ]
scientia non olet · About LEMON Manuals