On-Vehicle Inspection [03/2017 - ]: Procedure

INSPECT AIRBAG SENSOR ASSEMBLY (for Vehicle not Involved in Collision)
1. Perform a diagnostic system check.
  Refer to DTC CHECK / CLEAR [03/2017 - ]
INSPECT AIRBAG SENSOR ASSEMBLY (for Vehicle Involved in Collision and Airbag not Deployed)
1. Perform a diagnostic system check.
  Refer to DTC CHECK / CLEAR [03/2017 - ]
2. Visually check for defects with the airbag sensor assembly installed to the vehicle.
  HINT:
  
  The defects are as follows:
  - Cracks in the sensor housing
  - Dents in the sensor housing
  - Chips in the sensor housing
  - Cracks or other damage to the connectors
  - Peeling of the label
  OK
  
  No defects are found.
  
  If any defects are found, replace the airbag sensor assembly with a new one.
INSPECT AIRBAG SENSOR ASSEMBLY (for Vehicle Involved in Collision and Airbag is Deployed)
1. Replace the airbag sensor assembly.
  HINT:
  
  The airbag sensor assembly should be replaced after any of the SRS parts has deployed, as it has been subjected to an impact.