LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Camry LE, FWD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System - Service Information (1 Of 2) (Except Hybrid) >> KNEE AIRBAG ASSEMBLY (for Driver Side) >> Removal [10/2020 - ] >> Procedure

Removal [10/2020 - ]: Procedure

  1. PRECAUTION 
    WARNING:

    Be sure to read Precaution thoroughly before servicing.

    Refer to PRECAUTION [10/2020 - 08/2022] , or refer to PRECAUTION [08/2022 - ]

    GTY607029Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    NOTE:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Refer to PRECAUTION [03/2020 - ]

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 

    For A25A-FKS: Refer to PROCEDURE - Step 2

    For 2GR-FKS: Refer to PROCEDURE - Step 2

    WARNING:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    GTY684647Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [10/2020 - 08/2022] , or refer to INITIALIZATION [08/2022 - ]

  3. REMOVE FRONT DOOR SCUFF PLATE LH 

    Refer to PROCEDURE - Step 5 [10/2020 - 08/2021] , or refer to PROCEDURE - Step 5 [08/2021 - ]

  4. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH 

    Refer to PROCEDURE - Step 6 [10/2020 - 08/2021] , or refer to PROCEDURE - Step 6 [08/2021 - ]

  5. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH 

    HINT: 

    Disconnect the front door opening trim weatherstrip LH to the extent that allows the removal of the instrument side panel LH.

  6. REMOVE INSTRUMENT SIDE PANEL LH 

    Refer to PROCEDURE - Step 14

  7. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 15

  8. REMOVE NO. 2 METER HOOD CLUSTER 

    Refer to PROCEDURE - Step 16

  9. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 17

  10. REMOVE NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 18

  11. REMOVE NO. 1 METER HOOD CLUSTER 

    Refer to PROCEDURE - Step 1

  12. REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL 

    Refer to PROCEDURE - Step 4

  13. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY 
    WARNING:

    When storing the lower No. 1 instrument panel airbag assembly, keep the airbag deployment side facing upward.

    GTY540736Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    Deployment Side
    1. Check that the ignition switch is off.
    2. Check that the cable is disconnected from the negative (-) battery terminal.
      WARNING:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      GTY684647Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the 4 bolts.
      GTY748193Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Disengage the 2 claws and separate the lower No. 1 instrument panel airbag assembly.
      GTY748194Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      When separating the lower No. 1 instrument panel airbag assembly, do not pull the airbag wire harness.

    5. GTY750345Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Protective Tape
      *b Airbag Connector
      *c Airbag Connector Locking Button
      Release in this Direction

      Using a screwdriver with its tip wrapped with protective tape, release the airbag connector locking button.

    6. Disconnect the airbag connector to remove the lower No. 1 instrument panel airbag assembly.
      NOTE:

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

scientia non olet · About LEMON Manuals