LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Camry LE, FWD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System - Service Information (1 Of 2) (Except Hybrid) >> FRONT SEAT SIDE AIRBAG ASSEMBLY (for TMC Made) >> Installation [03/2017 - 09/2019] >> Procedure

Installation [03/2017 - 09/2019]: Procedure

  1. INSTALL FRONT SEAT AIRBAG ASSEMBLY 
    1. Install the front seat airbag assembly with 2 new nuts.

      Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf) 

      NOTE:
      • Do not reuse the nuts.
      • Make sure that the front seatback frame sub-assembly is not deformed. If it is deformed, replace it with a new one.
    2. Engage the clamp.
  2. INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD (for Power Seat) 

    Refer to PROCEDURE - Step 21 [03/2017 - 08/2018] , or refer to PROCEDURE - Step 22 [08/2018 - 09/2019]

  3. INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD (for Manual Seat) 

    Refer to PROCEDURE - Step 18

  4. INSTALL FRONT SEAT HEADREST SUPPORT (for Power Seat) 

    Refer to PROCEDURE - Step 22 [03/2017 - 08/2018] , or refer to PROCEDURE - Step 23 [08/2018 - 09/2019]

  5. INSTALL FRONT SEAT HEADREST SUPPORT (for Manual Seat) 

    Refer to PROCEDURE - Step 19

  6. INSTALL SEPARATE TYPE FRONT SEATBACK ASSEMBLY (for Power Seat) 

    Refer to PROCEDURE - Step 23 [03/2017 - 08/2018] , or refer to PROCEDURE - Step 24 [08/2018 - 09/2019]

  7. INSTALL SEPARATE TYPE FRONT SEATBACK ASSEMBLY (for Manual Seat) 

    Refer to PROCEDURE - Step 20

  8. INSTALL FRONT SEAT INNER CUSHION SHIELD (for Power Seat) 

    Refer to PROCEDURE - Step 30 [03/2017 - 08/2018] , or refer to PROCEDURE - Step 31 [08/2018 - 09/2019]

  9. INSTALL FRONT SEAT INNER CUSHION SHIELD (for Manual Seat) 

    Refer to PROCEDURE - Step 23

  10. INSTALL FRONT SEAT CUSHION SHIELD (for Power Seat) 

    Refer to PROCEDURE - Step 31 [03/2017 - 08/2018] , or refer to PROCEDURE - Step 32 [08/2018 - 09/2019]

  11. INSTALL FRONT SEAT CUSHION SHIELD (for Manual Seat) 

    Refer to PROCEDURE - Step 24

  12. INSTALL FRONT SEAT FRONT CUSHION SHIELD (for Power Seat) 

    Refer to PROCEDURE - Step 32 [03/2017 - 08/2018] , or refer to PROCEDURE - Step 33 [08/2018 - 09/2019]

  13. INSTALL SEAT ADJUSTER COVER CAP (for Manual Seat) 

    Refer to PROCEDURE - Step 25

  14. INSTALL RECLINING ADJUSTER RELEASE HANDLE (for Manual Seat) 

    Refer to PROCEDURE - Step 26

  15. INSTALL RECLINING HINGE COVER (for Manual Seat) 

    Refer to PROCEDURE - Step 27

  16. INSTALL VERTICAL ADJUSTING HANDLE (for Manual Seat) 

    Refer to PROCEDURE - Step 28

  17. CONNECT SEPARATE TYPE FRONT SEATBACK COVER (for Power Seat) 

    Refer to PROCEDURE - Step 33 [03/2017 - 08/2018] , or refer to PROCEDURE - Step 34 [08/2018 - 09/2019]

  18. CONNECT SEPARATE TYPE FRONT SEATBACK COVER (for Manual Seat) 

    Refer to PROCEDURE - Step 29

  19. INSTALL FRONT SEAT ASSEMBLY (for Power Seat) 

    Refer to INSTALLATION [03/2017 - 09/2019]

  20. INSTALL FRONT SEAT ASSEMBLY (for Manual Seat) 

    Refer to INSTALLATION [03/2017 - 09/2019]

  21. PERFORM DIAGNOSTIC SYSTEM CHECK 

    Refer to DTC CHECK / CLEAR [03/2017 - ]

scientia non olet · About LEMON Manuals