Caution / Notice / Hint
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Refer to PRECAUTION [03/2017 - 06/2017] , or refer to PRECAUTION [06/2017 - 09/2019] , or refer to PRECAUTION [09/2019 - 03/2020] , or refer to PRECAUTION [03/2020 - ]
HINT:
- Perform the simulation method by selecting check mode (Signal Check) using the Techstream.
Refer to CHECK MODE PROCEDURE [03/2017 - ]
- After selecting check mode (Signal Check), perform the simulation method by wiggling each connector of the airbag system or driving the vehicle on a city road or rough road.
Refer to HOW TO PROCEED WITH TROUBLESHOOTING [03/2017 - 06/2017] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [06/2017 - 08/2018] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2018 - 09/2019] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [09/2019 - 03/2020] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [03/2020 - 10/2020] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2020 - 08/2021] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2021 - ]