Removal [10/2020 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- REMOVE BATTERY
Refer to REMOVAL [10/2020 - ]
- REMOVE ECM
Refer to REMOVAL [10/2020 - 08/2022] , or refer to REMOVAL [08/2022 - ]
- REMOVE BATTERY CLAMP SUB-ASSEMBLY
Refer to PROCEDURE - Step 25 [10/2020 - 08/2022] , or refer to PROCEDURE - Step 25 [08/2022 - ]
- REMOVE FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)
Refer to REMOVAL [03/2020 - ]
- REMOVE FRONT LOWER NO. 1 FLOOR HEAT INSULATOR
- REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY
Refer to REMOVAL [03/2020 - ]
- REMOVE NO. 1 CONSOLE BOX DUCT (for Dual Type)
- REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY
- While disengaging the clip as shown in the illustration, disconnect the transmission control cable assembly from the transmission control shaft lever together with the clip.
*a Clip *b 45° to 60° - Remove the clip and disconnect the transmission control cable assembly from the No. 1 transmission control cable bracket.
- Remove the 2 nuts and disconnect the transmission control cable assembly from the vehicle body.
- Remove the 2 nuts and then remove the transmission control cable assembly from the vehicle body.
- While disengaging the clip as shown in the illustration, disconnect the transmission control cable assembly from the transmission control shaft lever together with the clip.