Removal [03/2017 - 09/2019]: Procedure
- REMOVE FRONT WHEEL OPENING EXTENSION PAD RH
Refer to PROCEDURE - Step 8 [03/2017 - 06/2017] , or refer to PROCEDURE - Step 8 [06/2017 - 08/2018] , or refer to PROCEDURE - Step 8 [08/2018 - 09/2019]
- REMOVE FRONT WHEEL OPENING EXTENSION PAD LH
Refer to PROCEDURE - Step 9 [03/2017 - 06/2017] , or refer to PROCEDURE - Step 9 [06/2017 - 08/2018] , or refer to PROCEDURE - Step 9 [08/2018 - 09/2019]
- REMOVE NO. 1 ENGINE UNDER COVER
Refer to PROCEDURE - Step 10 [03/2017 - 06/2017] , or refer to PROCEDURE - Step 10 [06/2017 - 08/2018] , or refer to PROCEDURE - Step 10 [08/2018 - 09/2019]
- REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY
Refer to PROCEDURE - Step 11 [03/2017 - 06/2017] , or refer to PROCEDURE - Step 11 [06/2017 - 08/2018] , or refer to PROCEDURE - Step 11 [08/2018 - 09/2019]
- REMOVE ENGINE OIL TEMPERATURE SENSOR
- Disconnect the engine oil temperature sensor connector.
- Using SST, remove the engine oil temperature sensor from the cylinder block sub-assembly.
- SST: 09817-33191
NOTE:If the engine oil temperature sensor has been struck or dropped, replace it.
- Remove the gasket from the engine oil temperature sensor.
- Disconnect the engine oil temperature sensor connector.