LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Camry LE, FWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System (A25A-FKS) - Service Information (Except Hybrid) >> Crankshaft Position Sensor >> Removal [10/2020 - ] >> Procedure

Removal [10/2020 - ]: Procedure

  1. REMOVE STARTER ASSEMBLY 

    Refer to REMOVAL [10/2020 - ]

  2. REMOVE CRANKSHAFT POSITION SENSOR 
    1. Disconnect the crankshaft position sensor connector.
      GTY754293Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using an 8 mm socket wrench, remove the bolt and crankshaft position sensor from the cylinder block sub-assembly.
      NOTE:

      If the crankshaft position sensor has been struck or dropped, replace it.

scientia non olet · About LEMON Manuals