Removal [03/2017 - ]: Procedure

REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 19 [03/2017 - 06/2017] , or refer to PROCEDURE - Step 19 [06/2017 - 08/2018] , or refer to PROCEDURE - Step 19 [08/2018 - 09/2019] , or refer to PROCEDURE - Step 19 [09/2019 - 03/2020] , or refer to PROCEDURE - Step 20 [03/2020 - 10/2020] , or refer to PROCEDURE - Step 20 [10/2020 - 08/2022] , or refer to PROCEDURE - Step 20 [08/2022 - ]

REMOVE CAMSHAFT POSITION SENSOR (for Intake Side)

Disconnect the camshaft position sensor connector.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Using an 8 mm socket wrench, remove the bolt and camshaft position sensor from the cylinder head cover sub-assembly.
NOTE:
If the camshaft position sensor has been struck or dropped, replace it.

REMOVE CAMSHAFT POSITION SENSOR (for Exhaust Side)

Using an 8 mm socket wrench, remove the bolt and camshaft position sensor from the cylinder head cover sub-assembly.

NOTE:

If the camshaft position sensor has been struck or dropped, replace it.