LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Camry LE, FWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System (A25A-FKS) - Service Information (Except Hybrid) >> Camshaft Oil Control Solenoid >> Removal [03/2017 - ] >> Procedure

Removal [03/2017 - ]: Procedure

  1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 19 [03/2017 - 06/2017] , or refer to PROCEDURE - Step 19 [06/2017 - 08/2018] , or refer to PROCEDURE - Step 19 [08/2018 - 09/2019] , or refer to PROCEDURE - Step 19 [09/2019 - 03/2020] , or refer to PROCEDURE - Step 20 [03/2020 - 10/2020] , or refer to PROCEDURE - Step 20 [10/2020 - 08/2022] , or refer to PROCEDURE - Step 20 [08/2022 - ]

  2. REMOVE NO. 2 BRAKE TUBE CLAMP BRACKET 
    1. Disengage the 3 clamps and remove the piping clamp.
      GTY754313Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      When removing and installing the piping clamp, be careful not to deform the suction pipe sub-assembly or air conditioning tube and accessory assembly.

    2. Remove the bolt to separate the No. 2 brake tube clamp bracket from the vehicle body.
      GTY754314Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Disengage the clamp and remove the No. 2 brake tube clamp bracket.
  3. REMOVE NO. 2 ENGINE COVER 

    Refer to PROCEDURE - Step 5 [03/2017 - 06/2017] , or refer to PROCEDURE - Step 5 [06/2017 - 08/2018] , or refer to PROCEDURE - Step 5 [08/2018 - 09/2019] , or refer to PROCEDURE - Step 5 [09/2019 - 03/2020] , or refer to PROCEDURE - Step 5 [03/2020 - 10/2020] , or refer to PROCEDURE - Step 5 [10/2020 - 08/2022] , or refer to PROCEDURE - Step 5 [08/2022 - ]

  4. REMOVE CAM TIMING OIL CONTROL SOLENOID ASSEMBLY 
    1. Disconnect the cam timing oil control solenoid assembly connector.
      GTY754315Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using an 8 mm socket wrench, remove the 2 bolts and cam timing oil control solenoid assembly from the No. 2 timing gear cover assembly.
      NOTE:

      If the cam timing oil control solenoid assembly has been struck or dropped, replace it.

  5. REMOVE O-RING 

    HINT: 

    Perform this procedure only when replacement of the O-ring is necessary.

    1. Remove the O-ring from the cam timing oil control solenoid assembly.
      NOTE:
      • When removing the O-ring, be careful not to damage the O-ring groove of the cam timing oil control solenoid assembly.
      • If the O-ring groove of the cam timing oil control solenoid assembly is damaged, replace the cam timing oil control solenoid assembly with a new one.
      GTY754922Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals