LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Camry LE, FWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System (A25A-FKS) - Service Information (Except Hybrid) >> Accelerator Pedal >> Removal [03/2017 - 06/2017] >> Procedure

Removal [03/2017 - 06/2017]: Procedure

  1. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 15

  2. REMOVE ACCELERATOR PEDAL SENSOR ASSEMBLY 
    NOTE:
    • Avoid physical shock to the accelerator pedal sensor assembly.
    • Do not disassemble the accelerator pedal sensor assembly.
    • The accelerator pedal sensor assembly does not require lubrication.
    • Do not apply oil or other lubricants to the accelerator pedal sensor assembly. If applied, the accelerator pedal sensor assembly must be replaced.
    1. Disconnect the accelerator pedal sensor assembly connector.
      GTY756543Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 3 nuts and disconnect the rod of the accelerator pedal sensor assembly from the accelerator pedal to remove the accelerator pedal sensor assembly.
      NOTE:

      If the accelerator pedal sensor assembly has been struck or dropped, replace it.

  3. REMOVE ACCELERATOR PEDAL PAD 
    1. Disengage the 4 claws and remove the accelerator pedal pad from the accelerator pedal.
      GTY756545Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE ACCELERATOR PEDAL 
    1. Remove the 2 bolts.
      GTY756548Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Push the accelerator pedal in the direction indicated by the arrow (1) shown in the illustration to disengage the claw.
      GTY741195Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Vehicle Body
      Remove in this Direction (1)
      Remove in this Direction (2)
    3. Pull the accelerator pedal in the direction indicated by the arrow (2) shown in the illustration to remove it.
scientia non olet · About LEMON Manuals