LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Camry LE, FWD >> Repair and Diagnosis >> Engine Mechanical >> Starter >> Engine Starting System (A25A-FKS) - Service Information (Except Hybrid) >> Starter >> Removal [03/2017 - 06/2017] >> Procedure

Removal [03/2017 - 06/2017]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Refer to PRECAUTION [03/2017 - 06/2017]

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 

    Refer to PROCEDURE - Step 2

  3. REMOVE FRONT ENGINE MOUNTING INSULATOR 

    Refer to REMOVAL [03/2017 - 03/2020]

  4. REMOVE FLYWHEEL HOUSING SIDE COVER 
    1. Disengage the claw as shown in the illustration to remove the flywheel housing side cover.
      GTY948015Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE STARTER ASSEMBLY 
    1. Disconnect the starter assembly connector.
      GTY958495Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Open the terminal cap.
    3. Remove the nut and disconnect the No. 2 engine wire from terminal 30.
      GTY957510Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Remove the 2 bolts and starter assembly from the cylinder block sub-assembly.
      GTY958479Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals