LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Camry LE, FWD >> Repair and Diagnosis >> Engine Mechanical >> Lubrication System >> Engine Lubrication System (A25A-FKS) - Service Information (Except Hybrid) >> Oil Pressure Sensor >> Removal [03/2017 - 09/2019] >> Procedure

Removal [03/2017 - 09/2019]: Procedure

  1. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH 

    Refer to PROCEDURE - Step 8 [03/2017 - 06/2017] , or refer to PROCEDURE - Step 8 [06/2017 - 08/2018] , or refer to PROCEDURE - Step 8 [08/2018 - 09/2019]

  2. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH 

    Refer to PROCEDURE - Step 9 [03/2017 - 06/2017] , or refer to PROCEDURE - Step 9 [06/2017 - 08/2018] , or refer to PROCEDURE - Step 9 [08/2018 - 09/2019]

  3. REMOVE NO. 1 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 10 [03/2017 - 06/2017] , or refer to PROCEDURE - Step 10 [06/2017 - 08/2018] , or refer to PROCEDURE - Step 10 [08/2018 - 09/2019]

  4. REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY 

    Refer to PROCEDURE - Step 11 [03/2017 - 06/2017] , or refer to PROCEDURE - Step 11 [06/2017 - 08/2018] , or refer to PROCEDURE - Step 11 [08/2018 - 09/2019]

  5. REMOVE OIL PRESSURE SENSOR (OIL PRESSURE SENDER GAUGE ASSEMBLY) 
    1. Disconnect the oil pressure sensor (oil pressure sender gauge assembly) connector.
    2. Using a 27 mm deep socket wrench, remove the oil pressure sensor (oil pressure sender gauge assembly) from the cylinder block sub-assembly.
      GTY753716Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals