Installation [09/2019 - ]: Procedure

1. Apply adhesive to the area shown in the illustration.

   Adhesive

   Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Oil Inlet Port
   *b	3 Threads or More
   	Adhesive Application Area

   NOTE:

   • Do not apply adhesive to the oil inlet port of the oil pressure and temperature sensor.
   • Apply the adhesive to the first 3 threads or more of the oil pressure and temperature sensor.
   • Apply adhesive to the entire circumference of the thread.
   • To prevent contamination by foreign matter, install immediately after applying adhesive.
2. Using a 24 mm deep socket wrench, install the oil pressure and temperature sensor.

   Torque: 15 N*m (153 kgf*cm, 11 ft.*lbf) 

   NOTE:

   Do not start the engine within 1 hour of installation.

3. Connect the oil pressure and temperature sensor connector.

Refer to PROCEDURE - Step 6 [09/2019 - 10/2020] , or refer to PROCEDURE - Step 6 [10/2020 - 08/2021] , or refer to PROCEDURE - Step 6 [08/2021 - 08/2023] , or refer to PROCEDURE - Step 6 [08/2023 - ]

Refer to PROCEDURE - Step 67 [08/2018 - 03/2020] , or refer to PROCEDURE - Step 72 [03/2020 - 10/2020] , or refer to PROCEDURE - Step 72 [10/2020 - ]

Refer to PROCEDURE - Step 68 [08/2018 - 03/2020] , or refer to PROCEDURE - Step 73 [03/2020 - 10/2020] , or refer to PROCEDURE - Step 73 [10/2020 - ]

Refer to PROCEDURE - Step 69 [08/2018 - 03/2020] , or refer to PROCEDURE - Step 74 [03/2020 - 10/2020] , or refer to PROCEDURE - Step 74 [10/2020 - ]

Refer to PROCEDURE - Step 70 [08/2018 - 03/2020] , or refer to PROCEDURE - Step 75 [03/2020 - 10/2020] , or refer to PROCEDURE - Step 75 [10/2020 - ]