Removal [10/2020 - ]: Procedure

DRAIN ENGINE COOLANT
Refer to PROCEDURE - Step 1
REMOVE GENERATOR ASSEMBLY
Refer to REMOVAL [10/2020 - ]
DISCONNECT NO. 2 RADIATOR HOSE
Refer to PROCEDURE - Step 33 [10/2020 - 08/2022] , or refer to PROCEDURE - Step 33 [08/2022 - ]

REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY

Disconnect the water inlet with thermostat sub-assembly connector.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Slide the clip and disconnect the No. 7 water by-pass hose from the water inlet with thermostat sub-assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NOTE:

Do not apply force to the water inlet with thermostat sub-assembly when disconnecting the No. 7 water by-pass hose.
Do not damage the water inlet with thermostat sub-assembly.

HINT:

When disconnecting the No. 7 water by-pass hose, slide the clip, rotate the hose and pull it straight off the pipe.

Using an 8 mm socket wrench, remove the 2 bolts and water inlet with thermostat sub-assembly.

Remove the gasket from the water inlet with thermostat sub-assembly.