Wireless Charger Power Source Circuit [08/2021 - ]: Procedure

1. Disconnect the k2 mobile wireless charger cradle assembly (front console box insert sub-assembly) connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   k2-1 (PGND) - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   k2-4 (B+) - Body ground	Always	11 to 14 V
   k2-3 (ACC) - Body ground	Engine switch on (ACC)	11 to 14 V

   Result

   Proceed to
   OK
   NG

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [03/2017 - ]  

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR