Wireless Charger Illumination Circuit [03/2017 - 08/2021]: Procedure

1. Disconnect the k1 mobile wireless charger cradle assembly (front console box insert sub-assembly) connector.
2. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   k1-10 (TAIL) - Body ground	Light control switch in off position	Below 1 V
   	Engine switch off, light control switch in tail or head position	11 to 14 V

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  2

1. Disconnect the K21 combination meter assembly connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   K21-1 (ILL-) - k1-9 (ILL-)	Always	Below 1 Ω
   K21-1 (ILL-) or k1-9 (ILL-) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [03/2017 - ]  

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR