Terminals Of Ecu [03/2017 - 08/2021]
- CHECK MOBILE WIRELESS CHARGER CRADLE ASSEMBLY (FRONT CONSOLE BOX INSERT SUB-ASSEMBLY)
Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition k1-1 (PGND) - Body ground W-B - Body ground Ground Always Below 1 V k1-5 (ACC) - k1-1 (PGND) P - W-B Power source (ACC) Engine switch on (ACC) 11 to 14 V Engine switch off Below 1 V k1-6 (B+) - k1-1 (PGND) G - W-B Power source (+B) Engine switch off 11 to 14 V k1-7 (DIS) - Body ground LG - Body ground Charging suspension signal For 5 seconds after turning engine switch from off to on (ACC)*1 4.5 to 6.0 V Device being charged Below 1 V Charging suspended due to smart entry and start system status*2 4.5 to 6.0 V k1-9 (ILL-) - Body ground L - Body ground Illumination (rheo stat) signal Light control switch in off position Below 1 V Light control switch in tail or head position Pulse generation k1-10 (TAIL) - Body ground W - Body ground Illumination signal Light control switch in off position Below 1 V Engine switch off, light control switch in tail or head position 11 to 14 V - *1: When the engine switch is turned from off to on (ACC), the mobile wireless charger cradle assembly (front console box insert sub-assembly) monitors the charging suspension signal for 5 seconds. If the charging suspension signal is not 4 V or more for 0.8 seconds or more during monitoring, the mobile wireless charger cradle assembly (front console box insert sub-assembly) determines that there is an open in the charging suspension signal line, blinks (pattern 1) the indicator light (amber), and prohibits operation until the engine switch is turned from off to on (ACC) again.
- *2: For details about conditions when the certification ECU (smart key ECU assembly) sends the charging suspension signal, refer to System Description.