Steering Pad Switch Circuit [03/2017 - ]: Procedure

1. Remove the steering pad switch assembly.

   Refer to REMOVAL [03/2017 - 06/2017] , or refer to REMOVAL [06/2017 - 10/2020] , or refer to REMOVAL [10/2020 - ]

2. Inspect the steering pad switch assembly.

   Refer to INSPECTION [03/2017 - 10/2020] , or refer to INSPECTION [10/2020 - 08/2021] , or refer to INSPECTION [08/2021 - ]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE STEERING PAD SWITCH ASSEMBLY. Refer to  REMOVAL [03/2017 - 06/2017]  , or refer to  REMOVAL [06/2017 - 10/2020]  , or refer to  REMOVAL [10/2020 - ] 

Result: 

OK 

See step  2

1. Remove the spiral cable sub-assembly.

   Refer to REMOVAL [03/2017 - 06/2017] , or refer to REMOVAL [06/2017 - 10/2020] , or refer to REMOVAL [10/2020 - ]

2. Inspect the spiral cable sub-assembly.

   Refer to INSPECTION [03/2017 - 03/2020] , or refer to INSPECTION [03/2020 - ]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE SPIRAL CABLE SUB-ASSEMBLY. Refer to  REMOVAL [03/2017 - 06/2017]  , or refer to  REMOVAL [06/2017 - 10/2020]  , or refer to  REMOVAL [10/2020 - ] 

Result: 

OK 

See step  3

1. Disconnect the K21 combination meter assembly connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   K22-10 (+DP2) - K21-28 (MSM+)	Always	Below 1 Ω
   K22-11 (+DP) - K21-29 (MSTI)	Always	Below 1 Ω
   K22-10 (+DP2) or K21-28 (MSM+) - Body ground	Always	10 kΩ or higher
   K22-11 (+DP) or K21-29 (MSTI) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [03/2017 - 06/2017]  , or refer to  REMOVAL [06/2017 - 10/2020]  , or refer to  REMOVAL [10/2020 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR