Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front drive shaft assembly removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Front wheel alignment adjustment |
|
|
w/ Electric Parking Brake System: Refer to CALIBRATION [10/2020 - 08/2021] , or refer to CALIBRATION [08/2021 - ] w/o Electric Parking Brake System: Refer to CALIBRATION [10/2020 - 08/2021] , or refer to CALIBRATION [08/2021 - ] |
| Automatic transaxle fluid | ATF thermal degradation estimate reset | The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly. | Refer to INITIALIZATION [09/2019 - ]
for UB80E Refer to INITIALIZATION [03/2020 - ] for UB80F |
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.