Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front drive shaft assembly removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Front wheel alignment adjustment | Perform system variant learning and acceleration sensor zero point calibration. |
|
w/ Electric Parking Brake System: Refer to CALIBRATION [06/2017 - 10/2020] w/o Electric Parking Brake System: Refer to CALIBRATION [06/2017 - 10/2020] |
| Automatic transaxle fluid | ATF thermal degradation estimate reset | The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly. | Refer to INITIALIZATION [09/2019 - ] |
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.