Caution / Notice / Hint
NOTE:
- Inspect the fuses for circuits related to this system before performing the following procedure.
- After replacing the skid control ECU (brake actuator assembly), perform acceleration sensor zero point calibration and system information memorization.
Refer to CALIBRATION [08/2021 - ]
- DTC precaution
Refer to PRECAUTION [10/2020 - ]
PROCEDURE TO CLEAR WARNING LIGHTS (WHEN NOT CLEARING DTCS)Procedure - Repair or replacement.
- Turn the ignition switch to ON.
- Drive the vehicle and depress the brake pedal 2 or 3 times to clear the warning lights.