DTC C146E: Open in ABS Solenoid Relay Circuit [06/2017 - 10/2020]: Procedure

1. Replace the skid control ECU (brake actuator assembly).

   Refer to REMOVAL [06/2017 - 10/2020]

   HINT: 

   This DTC is output when the skid control ECU (brake actuator assembly) detects a malfunction in an internal circuit.

2. Enter the following menus: Chassis / ABS/VSC/TRAC/EPB / Utility / Test Mode.
3. Perform system variant learning and acceleration sensor zero point calibration.

   Refer to CALIBRATION [06/2017 - 10/2020]

   Chassis > ABS/VSC/TRAC/EPB > Utility 

   Tester Display
   Test Mode

4. Enter the following menus: Chassis / ABS/VSC/TRAC/EPB / Utility / Signal Check.
5. Perform the sensor check using the Test Mode (Signal Check) procedure.

   Refer to TEST MODE PROCEDURE [06/2017 - 03/2020] , or refer to TEST MODE PROCEDURE [03/2020 - 10/2020]

   Chassis > ABS/VSC/TRAC/EPB > Utility 

   Tester Display
   Signal Check

   Result

   Proceed to
   NEXT

Result: 

NEXT 

END