DTC C1448: Yaw Rate Sensor Output Value [06/2017 - 10/2020]: Procedure

1. Clear the DTCs.

   Chassis > ABS/VSC/TRAC/EPB > Clear DTCs 

2. Turn the engine switch off.
3. Start and idle the engine.
4. Drive the vehicle at a speed of 20 km/h (12 mph) or more for at least 120 seconds, and then stop the engine.
5. Check if the same DTC is output.

   Chassis > ABS/VSC/TRAC/EPB > Trouble Codes 

   Result

   Result	Proceed to
   C1448 is output	A
   C1448 is not output	B

Result: 

A 

REPLACE AIRBAG SENSOR ASSEMBLY. Refer to  REMOVAL [06/2017 - 09/2019]  , or refer to  REMOVAL [09/2019 - 03/2020]  , or refer to  REMOVAL [03/2020 - 10/2020] 

Result: 

B 

USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [06/2017 - 08/2018]  , or refer to  HOW TO PROCEED WITH TROUBLESHOOTING [08/2018 - 09/2019]  , or refer to  HOW TO PROCEED WITH TROUBLESHOOTING [09/2019 - 03/2020]  , or refer to  HOW TO PROCEED WITH TROUBLESHOOTING [03/2020 - 10/2020]