Installation [06/2017 - ]: Procedure

INSTALL REAR FLEXIBLE HOSE

NOTE:

When installing the rear flexible hose, minimize twisting of the hose.

Install the rear flexible hose with a new clip.

NOTE:

Install the clip as far as it will go.
When installing the rear flexible hose, face the identification mark to the upper side of the vehicle.

*a	Identification Mark
*b	Torque Wrench Fulcrum Length
*c	Union Nut Wrench

Using a union nut wrench, connect the brake line to the rear flexible hose while holding the rear flexible hose with a wrench.
Specified tightening torque

Torque: 15.2 N*m (155 kgf*cm, 11 ft.*lbf)
NOTE:
- Do not kink or damage the brake line.
- Do not allow any foreign matter such as dirt or dust to enter the brake line from the connecting parts.
HINT:
- Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
  Refer to PRECAUTION [06/2017 - 09/2019] , or refer to PRECAUTION [09/2019 - 03/2020] , or refer to PRECAUTION [03/2020 - ]
- When using a union nut wrench (fulcrum length of 22 mm (0.866 in.)) + torque wrench (fulcrum length of 162 mm (6.38 in.)):
  13.4 N*m (137 kgf*cm, 10 ft.*lbf)
Install the rear flexible hose to the rear flexible hose bracket with the bolt.
Torque: 29 N*m (296 kgf*cm, 21 ft.*lbf)
Install the rear flexible hose to the rear disc brake cylinder assembly with a new union bolt and a new gasket.
Torque: 29 N*m (296 kgf*cm, 21 ft.*lbf)

NOTE:
Install the rear flexible hose lock securely into the lock hole in the rear disc brake cylinder assembly.