Disassembly [09/2019 - 08/2021]: Procedure

1. for Normal Roof:
   1. Remove the No. 2 roof silencer.

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. for Normal Roof:
   1. Remove the No. 4 roof silencer.

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT: 

Use the same procedure for the RH side and LH side.

1. Disengage the 2 claws (A) and separate the bulb holder from the vanity light assembly as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	Bulb Holder
   *a	Claw (A)
   *b	Claw (B)

2. Disengage the claw (B) to remove the vanity light assembly.

Refer to PROCEDURE - Step 6 [06/2017 - 10/2020] , or refer to PROCEDURE - Step 6 [10/2020 - ]

1. for Normal Roof:
   1. Remove the adhesive tape from the roof headlining assembly.

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      *A	w/ Room Light Assembly	*B	w/ Spot Light Assembly
      	Adhesive Tape	-	-

   2. Disengage 4 clamps and remove the No. 1 roof wire from the roof headlining assembly.

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      *A

      w/ Room Light Assembly

      *B

      w/ Spot Light Assembly

2. except Normal Roof:
   1. Remove the adhesive tape from the roof headlining assembly.

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      *A	for Moon Roof	*B	for Panoramic Moon Roof
      	Adhesive Tape	-	-

   2. Turn the 2 visor connectors counterclockwise approximately 90° and remove them from the roof headlining assembly.

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      *A	for Moon Roof	*B	for Panoramic Moon Roof
      *a	90°	-	-
      	Rotation Direction	-	-

   3. Disengage each clamp and remove the No. 1 roof wire from the roof headlining assembly.

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      *A

      for Moon Roof

      *B

      for Panoramic Moon Roof