- REMOVE INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY
Refer to PROCEDURE - Step 5
- REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT
- Remove the screw <C>.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
 |
Remove in this Direction |
- Disengage the 2 guides as shown in the illustration.
- Disengage the claw to remove the No. 1 side defroster nozzle duct as shown in the illustration.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
 |
Remove in this Direction |
- REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT
- Remove the 2 screws <C>.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
 |
Remove in this Direction |
- Disengage the 2 guides as shown in the illustration.
- Disengage the claw to remove the No. 2 side defroster nozzle duct as shown in the illustration.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
 |
Remove in this Direction |
- REMOVE DEFROSTER NOZZLE ASSEMBLY
- Remove the 3 screws <C> and defroster nozzle assembly.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE METER MIRROR SUB-ASSEMBLY (w/ Headup Display)
Refer to PROCEDURE - Step 5
- REMOVE NO. 1 HEATER TO REGISTER DUCT SUB-ASSEMBLY
- Remove the 2 screws <C> and No. 1 heater to register duct sub-assembly.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE NO. 3 HEATER TO REGISTER DUCT SUB-ASSEMBLY
- Remove the 2 screws <C> and No. 3 heater to register duct sub-assembly.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE ANTENNA CORD SUB-ASSEMBLY (w/o Navigation System)
Refer to PROCEDURE - Step 4
- REMOVE ANTENNA CORD SUB-ASSEMBLY (w/ Navigation System)
Refer to PROCEDURE - Step 4
- REMOVE NAVIGATION ANTENNA ASSEMBLY WITH BRACKET (w/ Navigation System)
Refer to PROCEDURE - Step 3
- REMOVE TELEPHONE AND GPS ANTENNA CORD (w/ Manual (SOS) Switch)
Refer to PROCEDURE - Step 4
- REMOVE TELEPHONE AND GPS ANTENNA ASSEMBLY WITH BRACKET (w/ Manual (SOS) Switch)
Refer to PROCEDURE - Step 3
- REMOVE AUTOMATIC LIGHT CONTROL SENSOR
Refer to PROCEDURE - Step 5
- REMOVE NO. 3 INSTRUMENT PANEL WIRE
- Disengage the clamp to remove the No. 3 instrument panel wire.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE RADIO TUNER FINISH RETAINER
- Remove the 5 screws <C> and radio tuner finish retainer.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE NO. 1 METER BRACKET SUB-ASSEMBLY
- Remove the screw <C> and No. 1 meter bracket sub-assembly.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE NO. 2 METER BRACKET SUB-ASSEMBLY (w/ Headup Display)
- Remove the screw <C> and No. 2 meter bracket sub-assembly.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE NO. 1 DEFROSTER NOZZLE GARNISH
- Disengage the 4 clips.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Disengage the 5 guides to remove the No. 1 defroster nozzle garnish.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE INSTRUMENT PANEL HOLE COVER (w/ Headup Display)
- Disengage the 5 claws.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Disengage the 3 guides to remove the instrument panel hole cover.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE NO. 1 INSTRUMENT PANEL PIN
- Remove the 4 screws <C> and 4 No. 1 instrument panel pins.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE INSTRUMENT PANEL CUSHION
- Remove the instrument panel cushion.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|