Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front bumper assembly removal/installation are shown below.
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Front bumper assembly (w/ Panoramic view monitor system) | Front television camera view adjustment | Panoramic View Monitor System | Refer to INITIALIZATION [10/2020 - ]
for Initialization Refer to CALIBRATION [10/2020 - ] for Calibration |
Replacement or removal and installation of 2 or more parts:
|
|
*1: Applies only for when removing and installing or replacing the rear television camera assembly.
HINT:
When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform millimeter wave radar sensor adjustment.
Target Adjustment (Triangle Target):
Refer to TARGET ADJUSTMENT (TRIANGLE TARGET) [10/2020 - ]
Target Adjustment (Flat Surface Target):
Refer to TARGET ADJUSTMENT (FLAT SURFACE TARGET) [10/2020 - ]
Driving Adjustment:
Refer to DRIVING ADJUSTMENT [10/2020 - ]