Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front bumper assembly removal/installation are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Front bumper assembly (w/ Panoramic view monitor system) | Front television camera view adjustment | Panoramic view monitor system | Refer to INITIALIZATION [06/2017 - 10/2020]
for Initialization Refer to CALIBRATION [06/2017 - 10/2020] for Calibration |
HINT:
When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform millimeter wave radar sensor adjustment.
Refer to ADJUSTMENT [06/2017 - 10/2020]