LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Camry LE, FWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Door / Hatch - Service Information (2 Of 2) (Except Hybrid) >> Fuel Lid Opener Switch >> Inspection [03/2017 - ] >> Procedure

Inspection [03/2017 - ]: Procedure

  1. INSPECT FUEL LID OPENER SWITCH 
    1. Check the switch.
      GTY762850Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Fuel Lid Opener Switch)
      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection Condition Specified Condition
        2 - 5 Pressed (ON) Below 1 Ω
        2 - 5 Not pressed (OFF) 10 kΩ or higher

        If the result is not as specified, replace the fuel lid opener switch.

    2. Check the switch illumination.
      1. Apply battery voltage to the switch connector and check that the fuel lid opener switch illuminates.

        OK

        Battery Condition Specified Condition
        Battery positive (+) → Terminal 6
        Battery negative (-) → Terminal 1        		 Illumination illuminates

        If the result is not as specified, replace the fuel lid opener switch.

scientia non olet · About LEMON Manuals