LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Camry LE, FWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Door / Hatch - Service Information (1 Of 2) (Except Hybrid) >> Hood >> Disassembly [10/2020 - ] >> Procedure

Disassembly [10/2020 - ]: Procedure

  1. REMOVE HOOD TO RADIATOR SUPPORT SEAL 
    1. Using a clip remover, disengage the 10 hood to radiator support seal clips to remove the hood to radiator support seal.
      GTY1015369Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 10 hood to radiator support seal clips from the hood to radiator support seal.
  2. REMOVE HOOD INSULATOR 
    1. Using a clip remover, remove the 9 hood insulator clips.
      GTY1015367Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the 2 guides to remove the hood insulator.
  3. REMOVE WASHER NOZZLE SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 1

  4. DISCONNECT WASHER HOSE ASSEMBLY 
    1. Disengage the 5 clamps.
      GTY1015363Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the grommet and disconnect the washer hose assembly.
  5. REMOVE HOOD STAY HOLDER 
    1. Disengage the 2 claws to remove the hood stay holder.
      GTY1015358Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE HOOD SUPPORT ASSEMBLY 
    1. Disengage the 4 claws to remove the hood support assembly.
      GTY1015380Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. REMOVE HOOD STAY BRACKET RH 
    1. Remove the bolt.
      GTY1015377Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the guide to remove the hood stay bracket RH.
scientia non olet · About LEMON Manuals