Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear seatback lock assembly removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Disconnect cable from negative battery terminal | Perform steering sensor zero point calibration | Lane Tracing Assist System | Refer to INITIALIZATION [10/2020 - ] |
| Pre-collision System | |||
| Memorize steering angle neutral point | Parking Assist Monitor System | Refer to INITIALIZATION [03/2017 - ] | |
| Panoramic View Monitor System | Refer to INITIALIZATION [10/2020 - ] |
WARNING:
- Wear protective gloves. Sharp areas on the parts may injure your hands.
- Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Refer to PRECAUTION [10/2020 - 08/2022] , or refer to PRECAUTION [08/2022 - ]