Caution / Notice / Hint

NOTE:

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.
Refer to PRECAUTION [06/2017 - 10/2020]
When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occur:
- A communication malfunction DTC may be stored.
- The radio and display receiver assembly may not operate normally.
Check that the antenna cord sub-assembly (for Navigation Antenna) is properly installed and does not have any sharp bends, pinching or loose connections before performing following procedure.
Refer to HOW TO PROCEED WITH TROUBLESHOOTING [06/2017 - 08/2018] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2018 - 09/2019] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [09/2019 - 03/2020] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [03/2020 - 10/2020]