| Steering Angle Sensor Communication Stop Mode |
Any of the following conditions are met:
- Communication stop for "Spiral cable (Steering Angle Sensor)" is indicated on the "Communication Bus Check" screen of the Techstream.
Refer to PROBLEM SYMPTOMS TABLE [03/2017 - 06/2017]
, or refer to PROBLEM SYMPTOMS TABLE [06/2017 - 03/2020]
, or refer to PROBLEM SYMPTOMS TABLE [03/2020 - 10/2020]
, or refer to PROBLEM SYMPTOMS TABLE [10/2020 - ]
- Communication stop history for "Spiral cable (Steering Angle Sensor)" is indicated on the "Communication Bus Check (Detail)" screen of the Techstream. (The Lost Communication Time value for "Spiral cable (Steering Angle Sensor)" is 6 or more.)
Refer to PROBLEM SYMPTOMS TABLE [03/2017 - 06/2017]
, or refer to PROBLEM SYMPTOMS TABLE [06/2017 - 03/2020]
, or refer to PROBLEM SYMPTOMS TABLE [03/2020 - 10/2020]
, or refer to PROBLEM SYMPTOMS TABLE [10/2020 - ]
- Communication system DTCs (DTCs that start with U) that correspond to "Steering Angle Sensor Communication Stop Mode" in "DTC Combination Table" are output.
Refer to DTC COMBINATION TABLE [03/2017 - 06/2017]
, or refer to DTC COMBINATION TABLE [06/2017 - 08/2018]
, or refer to DTC COMBINATION TABLE [08/2018 - 09/2019]
, or refer to DTC COMBINATION TABLE [09/2019 - 03/2020]
, or refer to DTC COMBINATION TABLE [03/2020 - 10/2020]
, or refer to DTC COMBINATION TABLE [10/2020 - 08/2021]
, or refer to DTC COMBINATION TABLE [08/2021 - ]
|
- Steering sensor branch line or connector
- Power source circuit of steering sensor
- Steering sensor ground circuit
- Steering sensor
|