| Blind Spot Monitor Sensor Communication Stop Mode |
Any of the following conditions are met:
- Communication stop for "Blind Spot Monitor Master" is indicated on the "Communication Bus Check" screen of the Techstream.
Refer to PROBLEM SYMPTOMS TABLE [03/2017 - 06/2017]
, or refer to PROBLEM SYMPTOMS TABLE [06/2017 - 03/2020]
, or refer to PROBLEM SYMPTOMS TABLE [03/2020 - 10/2020]
, or refer to PROBLEM SYMPTOMS TABLE [10/2020 - ]
- Communication stop history for "Blind Spot Monitor Master" is indicated on the "Communication Bus Check (Detail)" screen of the Techstream. (The Lost Communication Time value for "Blind Spot Monitor Master" is 6 or more.)
Refer to PROBLEM SYMPTOMS TABLE [03/2017 - 06/2017]
, or refer to PROBLEM SYMPTOMS TABLE [06/2017 - 03/2020]
, or refer to PROBLEM SYMPTOMS TABLE [03/2020 - 10/2020]
, or refer to PROBLEM SYMPTOMS TABLE [10/2020 - ]
- Communication system DTCs (DTCs that start with U) that correspond to "Blind Spot Monitor Sensor Communication Stop Mode" in "DTC Combination Table" are output.
Refer to DTC COMBINATION TABLE [03/2017 - 06/2017]
, or refer to DTC COMBINATION TABLE [06/2017 - 08/2018]
, or refer to DTC COMBINATION TABLE [08/2018 - 09/2019]
, or refer to DTC COMBINATION TABLE [09/2019 - 03/2020]
, or refer to DTC COMBINATION TABLE [03/2020 - 10/2020]
, or refer to DTC COMBINATION TABLE [10/2020 - 08/2021]
, or refer to DTC COMBINATION TABLE [08/2021 - ]
|
- Blind spot monitor sensor RH branch line or connector
- Power source circuit of blind spot monitor sensor RH
- Blind spot monitor sensor RH ground circuit
- Blind spot monitor sensor RH
|