Caution / Notice / Hint

NOTE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Refer to PRECAUTION [02/2017 - 05/2018] , or refer to PRECAUTION [05/2018 - ]

HINT:

Perform the simulation method by selecting check mode (Signal Check) using the Techstream.
Refer to CHECK MODE PROCEDURE [02/2017 - ]
After selecting check mode (Signal Check), perform the simulation method by wiggling each connector of the airbag system or driving the vehicle on a city road or rough road.
Refer to HOW TO PROCEED WITH TROUBLESHOOTING [02/2017 - 10/2017] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2017 - 05/2018] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [05/2018 - 09/2019]