LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> C-HR XLE >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Air Conditioning System - Service Information (1 Of 3) >> COMPRESSOR (for VALEO Made) >> Removal [12/2021 - ] >> Procedure

Removal [12/2021 - ]: Procedure

  1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM 

    Refer to PROCEDURE - Step 1

  2. REMOVE NO. 1 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 7

  3. REMOVE FAN AND GENERATOR V BELT 

    Refer to REMOVAL [02/2017 - ]

  4. DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY 
    1. Disconnect the connector.
      GTY773962Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt to disconnect the discharge hose sub-assembly from the compressor with pulley assembly.
    3. Remove the O-ring from the discharge hose sub-assembly.
      NOTE:

      Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.

  5. DISCONNECT SUCTION HOSE SUB-ASSEMBLY 
    1. Remove the bolt to disconnect the suction hose sub-assembly from the compressor with pulley assembly.
      GTY765219Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the O-ring from the suction hose sub-assembly.
      NOTE:

      Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.

  6. REMOVE COMPRESSOR WITH PULLEY ASSEMBLY 
    1. Remove the 2 bolts and 2 nuts.
      GTY765218Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using an E8 "TORX" socket wrench, remove the 2 stud bolts and compressor with pulley assembly.

      HINT: 

      Remove the compressor with pulley assembly from the vehicle with the stud bolts remaining in the compressor with pulley assembly.

      GTY761121Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals