LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> C-HR XLE >> Repair and Diagnosis >> Engine Mechanical >> Starter >> Starting System - Service Information >> Starter >> Installation [09/2019 - 08/2020] >> Procedure

Installation [09/2019 - 08/2020]: Procedure

  1. INSTALL STARTER ASSEMBLY 
    1. Install the starter assembly to the cylinder block sub-assembly with the 2 bolts.

      Torque: 46 N*m (469 kgf*cm, 34 ft.*lbf) 

    2. Connect the wire harness to the terminal 30 with the nut.

      Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf) 

    3. Close the terminal cap.
    4. Connect the starter assembly connector.
  2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 

    Refer to PROCEDURE - Step 2

    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [09/2019 - 08/2020]

  3. INSTALL NO. 1 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 61

scientia non olet · About LEMON Manuals