LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> C-HR XLE >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - Service Information (1 Of 2) >> Drive Belt >> On-Vehicle Inspection [02/2017 - ] >> Procedure

On-Vehicle Inspection [02/2017 - ]: Procedure

  1. INSPECT FAN AND GENERATOR V BELT 
    1. Check the fan and generator V belt for wear, cracks or other signs of damage.
      GTY764768Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      If any of the following defects is found, replace the fan and generator V belt.

      • The fan and generator V belt is cracked.
      • The fan and generator V belt is worn out to the extent that the cords are exposed.
      • The fan and generator V belt has chunks missing from the ribs.
    2. Check that the fan and generator V belt fits properly in the ribbed grooves.
      GTY765632Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Correct
      *b Incorrect

      HINT: 

      Check with your hand to confirm that the fan and generator V belt has not slipped out of the grooves on the bottom of the pulley. If it has slipped out, replace the fan and generator V belt. Install a new fan and generator V belt correctly.

scientia non olet · About LEMON Manuals