Removal [08/2020 - ]: Procedure

Refer to REMOVAL [08/2020 - ] 

1. Remove the 2 bolts and No. 1 water by-pass pipe.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Refer to PROCEDURE - Step 42

1. Using a 10 mm bi-hexagon wrench, uniformly loosen and remove the 10 cylinder head set bolts and 10 plate washers in several steps in the order shown in the illustration.
   Fig 1: Cylinder Head Sub-Assembly Loosening Sequence

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   NOTE:

   • Removing the cylinder head set bolts in the wrong order may cause warpage or cracking of the cylinder head sub-assembly.
   • Do not drop the plate washers into the cylinder head sub-assembly.
2. Using a screwdriver, remove the cylinder head sub-assembly by prying between the cylinder head sub-assembly and cylinder block sub-assembly.
   NOTE:

   Be careful not to damage the contact surfaces of the cylinder head sub-assembly and cylinder block sub-assembly.

   HINT: 

   Tape the screwdriver tip before use.

1. Remove the cylinder head gasket from the cylinder block sub-assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Refer to PROCEDURE - Step 1

Refer to PROCEDURE - Step 14