Removal [08/2020 - ]: Procedure
- PRECAUTION NOTE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Refer to PRECAUTION [05/2018 - ]
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Refer to PROCEDURE - Step 2
- REMOVE FAN AND GENERATOR V BELT
Refer to PROCEDURE - Step 2
- REMOVE GENERATOR ASSEMBLY
- Remove the terminal cap from the generator assembly.
- Remove the nut to disconnect the engine wire from terminal B.
- Disconnect the generator assembly connector.
- Disengage the clamp to disconnect the wire harness from the wire harness clamp bracket.
- Remove the 2 bolts and generator assembly.
- Remove the bolt and wire harness clamp bracket from the generator assembly.
- Remove the terminal cap from the generator assembly.