LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> C-HR XLE >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brake System (Hydraulic) - Service Information >> Vacuum Warning Switch >> Removal [12/2021 - ] >> Procedure

Removal [12/2021 - ]: Procedure

  1. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY 

    Refer to REMOVAL [12/2021 - ]

  2. REMOVE NO. 1 HEATER AIR DUCT SPLASH SHIELD SEAL 

    Refer to PROCEDURE - Step 3

  3. REMOVE WATER GUARD PLATE LH 

    Refer to PROCEDURE - Step 4

  4. REMOVE COWL BODY MOUNTING REINFORCEMENT LH 

    Refer to PROCEDURE - Step 5

  5. REMOVE COWL BODY MOUNTING REINFORCEMENT RH 

    Refer to PROCEDURE - Step 6

  6. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 7

  7. REMOVE BATTERY 

    Refer to REMOVAL [08/2020 - ]

  8. REMOVE VACUUM WARNING SWITCH ASSEMBLY (for TMC Made) 
    1. Disconnect the connector from the vacuum warning switch assembly.
      GTY892583Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the vacuum warning switch assembly from the brake booster assembly.
    3. Remove the check valve grommet from the brake booster assembly.
  9. REMOVE VACUUM WARNING SWITCH ASSEMBLY (for TMMT Made) 
    1. Disconnect the connector from the vacuum warning switch assembly.
      GTY750618Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the vacuum warning switch assembly from the brake booster assembly.
    3. Remove the check valve grommet from the brake booster assembly.
scientia non olet · About LEMON Manuals