LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> C-HR XLE >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brake System (Hydraulic) - Service Information >> Brake Pedal >> Removal [08/2020 - ] >> Procedure

Removal [08/2020 - ]: Procedure

  1. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY 

    Refer to REMOVAL [08/2020 - 12/2021] , or refer to REMOVAL [12/2021 - ]

  2. REMOVE STOP LIGHT SWITCH ASSEMBLY 

    Refer to REMOVAL [08/2020 - ]

  3. REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER 
  4. REMOVE BRAKE PEDAL RETURN SPRING 
    1. Remove the brake pedal return spring from the brake pedal support assembly and push rod pin.
      GTY770478Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE PUSH ROD PIN 
    1. Remove the clip and push rod pin to separate the brake pedal support assembly from the brake master cylinder push rod clevis.
      GTY749433Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY 
    1. Disconnect the brake pedal load sensing switch connector.
      GTY749444Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the clamp to separate the wire harness from the brake pedal support assembly.
    3. Remove the bolt and separate the brake pedal support assembly from the instrument panel reinforcement assembly.
      GTY768863Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Remove the 2 clips.
      GTY749441Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Remove the 4 nuts and brake pedal support assembly.
    6. Remove the nut from the brake pedal support assembly.
      GTY749442Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. REMOVE BRAKE PEDAL PAD 
    1. Remove the brake pedal pad from the brake pedal support assembly.
scientia non olet · About LEMON Manuals