Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the brake master cylinder sub-assembly removal/installation are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replacement Part or Procedure | Necessary Procedures | Effects / Inoperative when not performed | Link |
|---|---|---|---|
| Disconnect cable from negative battery terminal | Memorize steering angle neutral point | Lane departure alert system (w/ Steering Control) | Refer to INITIALIZATION [02/2017 - 08/2020] |
| Pre-collision system | |||
| Initialize back door lock | Power door lock control system | Refer to INITIALIZATION [02/2017 - ] |
NOTE:
Make sure to release vacuum from the brake booster assembly before removing the master cylinder sub-assembly from the brake booster assembly.