LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> C-HR XLE >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brake System (Hydraulic) - Service Information >> Brake Master Cylinder >> Disassembly [02/2017 - 09/2019] >> Procedure

Disassembly [02/2017 - 09/2019]: Procedure

  1. REMOVE BRAKE MASTER CYLINDER RESERVOIR ASSEMBLY 
    1. Mount the brake master cylinder sub-assembly in a vise.
      NOTE:

      Place aluminum plates on the vise to prevent damage to the brake master cylinder sub-assembly.

    2. Using an T20 "TORX" socket wrench, remove the "TORX" screw and brake master cylinder reservoir assembly from the brake master cylinder body.
      GTY750659Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      Do not drop the brake master cylinder reservoir assembly.

    3. Remove the brake master cylinder body from the vise.
    4. Disengage the claw to remove the wire harness clamp.
  2. REMOVE MASTER CYLINDER RESERVOIR GROMMET 
    1. Remove the 2 master cylinder reservoir grommets from the brake master cylinder reservoir assembly.
  3. REMOVE BRAKE MASTER CYLINDER RESERVOIR FILLER CAP ASSEMBLY 
    1. Remove the brake master cylinder reservoir filler cap assembly from the brake master cylinder reservoir assembly.
  4. REMOVE BRAKE MASTER CYLINDER RESERVOIR STRAINER 
    1. Remove the brake master cylinder reservoir strainer from the brake master cylinder reservoir assembly.
scientia non olet · About LEMON Manuals