Inspection [02/2017 - ]: Procedure

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Switch Condition	Specified Condition
   4 (IG) - 1 (E)	Pressed (ON)	Below 1 Ω
   4 (IG) - 1 (E)	Not pressed (OFF)	10 kΩ or higher

   If the result is not as specified, replace the fuel lid opener switch.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Check that the LED illuminates.

1. Apply battery voltage to the fuel lid opener switch and check that the fuel lid opener switch illuminates.

   OK

   Measurement Condition	Specified Condition
   Battery positive (+) → 3 (ILL+)	LED illuminates
   Battery negative (-) → 2 (ILL-)

   If the result is not as specified, replace the fuel lid opener switch.