Customize Parameters [02/2017 - ]

CUSTOMIZE METER / GAUGE SYSTEM

Customizing with the Techstream.

Connect the Techstream to the DLC3.
Turn the ignition switch ON.
Turn the Techstream on.
Enter the following menus: Customize Setting / Warning or Display.

Select the setting by referring to the chart below.

NOTE:

Be sure to record the current value before customizing.

Display

Tester Display	Description	Default	Setting	ECU
ECO Drive Indicator Zone	Function to change the ECO Drive Indicator Zone	ON	0:OFF, 1:ON	Combination meter assembly
ECO Drive Indicator Light	Function to change the ECO Drive Indicator light*1	ON	0:OFF, 1:ON	Combination meter assembly
ODO Display Time After IG OFF Setting	Function to change the ODO display time after the ignition switch is turned off	30s	00:30s, 01:60s, 10:600s, 11:OFF	Combination meter assembly

Warning

Tester Display	Description	Default	Setting	ECU
Flasher Sound Tone Setting	Function to change the flasher sound tone	Tone 1	00:Tone 1, 01:Tone 2, 10:Tone 3	Combination meter assembly
Lane Change Flashing Times Setting	Function to change the lane change flashing time	3	000:OFF, 001:3, 010:4, 011:5, 100:6, 101:7	Combination meter assembly