Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear coil spring removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Rear wheel alignment adjustment |
|
|
Refer to CALIBRATION [10/2017 - 12/2021] , or refer to CALIBRATION [12/2021 - ] |
| Removal/installation of rear height control sensor sub-assembly LH*1 | Initialize headlight ECU sub-assembly LH | Automatic headlight beam level control system | Refer to INITIALIZATION [10/2017 - 09/2019] , or refer to INITIALIZATION [09/2019 - 08/2020] , or refer to INITIALIZATION [08/2020 - ] |
| Suspension, tires, etc. (The vehicle height changes because of suspension or tire replacement)*1 |
- *1: w/ Height Control Sensor
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.